Error Code E It
Defect of ice maker kit — malfunction of in-door ice maker motor
Moderate
Address soon - your appliance may not work properly
Also displayed as: E It
How to Fix
- 1
Step 1: Press and hold the FILL key for 3 seconds to enter icemaker test mode.
- 2
Step 2: Observe if icemaker runs 2 stages: harvest and fill water. If it completes both stages, mechanism is normal.
- 3
Step 3: If mechanism does not cycle, check wiring harness connection from Main PCB to icemaker.
- 4
Step 4: Check icemaker motor resistance. Replace icemaker unit if motor is defective.
- 5
Step 5: If harness is good and motor resistance is correct but error persists, replace Main PCB.
This Error Applies To
LG LRYXC2606 Series Refrigerators
Related Error Codes
Defect of freezer craft ice maker sensor — short-circuit or disconnection of craft ice maker sensor
Defect of Mini Cubed ice maker kit — malfunction of Mini Cubed ice maker motor
Defect of refrigerator sensor — short-circuit or disconnection of refrigerator sensor
Defect of freezer sensor — short-circuit or disconnection of freezer sensor
Defrosting failure — defrost sensor does not reach 40°F (5°C) within 80 minutes after defrost starts. Causes: disconnected thermal fuse, defective defrost heater, defective heater relay, drain tube blockage.
Defect of BLDC fan motor for freezer — no feedback signal from fan motor for more than 65 seconds
Defect of BLDC fan motor for ice compartment — no feedback signal from fan motor for more than 65 seconds. Causes: defect of BLDC motor connection, Drive IC, or TR.
Defect of BLDC fan motor for machine room — no feedback signal from condenser fan motor for more than 65 seconds